Attention!

wagross · 02-09-2006, 05:31 AM

For the last two days, since I have been charting, your S1 and R1 have been off by 1/4 point in the ES, as measured against both my own calculation and found here:

http://www.deltat1.com/DailyNotes/dailynotes.aspx

At least for today, the balance of your pivot series numbers are correct.

NinjaTrader_Dierk · 02-09-2006, 07:36 AM

NT pivot code is exposed at <install>\bin\Custom\Indicator\@Pivots.cs (starting NT5.1B2).

In order to figure out if calculations are off you need to make sure
a) math is done on the same data (check high/low/last values on actual NT chart)
b) algorithm is the same

Note: Woodies Pivots are calculated differently, than standard pivots.

02-09-2006, 05:31 AM	#1
wagross Member Join Date: Nov 2004 Location: Palm Desert, California, USA Posts: 36 Thanks: 0 Thanked 0 times in 0 posts	imported post For the last two days, since I have been charting, your S1 and R1 have been off by 1/4 point in the ES, as measured against both my own calculation and found here: http://www.deltat1.com/DailyNotes/dailynotes.aspx At least for today, the balance of your pivot series numbers are correct.
	Facebook Twitter YouTube

02-09-2006, 07:36 AM	#2
NinjaTrader_Dierk Administrator Join Date: Mar 2005 Location: Bamberg, Germany Posts: 9,994 Thanks: 0 Thanked 6 times in 6 posts	imported post NT pivot code is exposed at <install>\bin\Custom\Indicator\@Pivots.cs (starting NT5.1B2). In order to figure out if calculations are off you need to make sure a) math is done on the same data (check high/low/last values on actual NT chart) b) algorithm is the same Note: Woodies Pivots are calculated differently, than standard pivots. Dierk NinjaTrader Customer Service Use Kinetick, NinjaTrader’s preferred market data service - Learn More Free online training events - View Schedule
	Facebook Twitter YouTube

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode