Ray

[JohnG]

Would it be possible to add the ability to cut a ray at a point of our choosing? If, for example, in a trend with a ray drawn, price crosses over the ray extension against the trend. You no longer need a long line extending to the right, but still want to keep the part of the ray that is before the price crossover--it would be great if you could cut it at that point to make your chart less cluttered.

[NinjaTrader_Dierk]

Thanks for your suggestion. We'll add it to the list.

[CS1LVA]

Aye Ray,
I use a 4 min chart, but I start it at 12:02AM to 12:00AM, the bar timer does not work with that start time.
FYI the reason i want that start time is so I get a bar at 8:30CST and don't get caught in the middle of the bar at that specific time.

See what the developer can do to remedy that detail.

Thanks again
Carlos

[NinjaTrader_Dierk]

Not sure I follow. Please elaborate.

Also: Please make sure you are on latest 6.0.1000.4

[CS1LVA]

thank you for looking at my question.
This is what I mean.
put up a chart , lets say ER2 09-07,
in the format series choose 4 minutes,
now you go to the chart and open properties.
In the Data Series section type in where it says session begin,
type in 12:02AM
where it says session ends type in 12:00 AM,
Hit Apply , now right click mouse , choose Bar Timer indicator,
hit apply again, and you will see that the Bar timer line on the lower right hand side of the chart says: Bar Timer disabled since current time is out of session time.

thats the problem
I do not want to start my session at 12:00 because the bar close will be 8:32AM when the time comes , I want to print an 8:30 bar close.

Thanks in advance
Carlos

[NinjaTrader_Dierk]

Thanks for clarification. This is a bug which will be fixed with next update. For now you could set the session end time to a non-default value like 11:59 PM.

Thanks for pointing out that issue.