How do we reenable the Rollover dialog and New Version dialog.

[shawnj]

I checked the "dont show this again" check box of the "Rollover notification dialog" that pops up when we launch NT. How can we reenable that dialog (as though we had not checked the checkbox) and the dialog that pops up when a new version of NT is available. I assume this is a registry key or something like that.

thanks,
shawnj

[NinjaTrader_VinceB]

Hi,

It's not possible to reactivate the message box. We implemented this as a notification.

[NinjaTrader_Dierk]

To clarify: This box will pop up again as we publish a new release -> you will get notified on a new release.

[shawnj]

Thanks. I'm writing an automation script to launch NT. NT turns out to be not very "friendly" to scripting - no hotkeys and random dialog boxes at startup - the "new release" dialog and "rollover" dialog and I don't rember if there are any others.

I was hoping I could "trigger" the dialogs to test my script against. I guess I'll struggle thru another way.

[NinjaTrader_Jessica]

We will have the next release of 6.5 out within the next week and you can test against this message. As long as you do not check the "do not show this message again" box you will be able to test it as many time as needed.

[shawnj]

Thanks. I though I would be cleaver and uninstall 6.5.1000.3 and install 6.5.1000.2. However launching 6.5.1000.2 does not trigger the "new release" dialog. . Guess I'll have to wait.