Announcement
Collapse
No announcement yet.
Partner 728x90
Collapse
NinjaTrader
Ray
Collapse
X
-
Ray
Would it be possible to add the ability to cut a ray at a point of our choosing? If, for example, in a trend with a ray drawn, price crosses over the ray extension against the trend. You no longer need a long line extending to the right, but still want to keep the part of the ray that is before the price crossover--it would be great if you could cut it at that point to make your chart less cluttered.Tags: None
-
Bar Timer
Aye Ray,
I use a 4 min chart, but I start it at 12:02AM to 12:00AM, the bar timer does not work with that start time.
FYI the reason i want that start time is so I get a bar at 8:30CST and don't get caught in the middle of the bar at that specific time.
See what the developer can do to remedy that detail.
Thanks again
Carlos
Comment
-
Bar Timer
thank you for looking at my question.
This is what I mean.
put up a chart , lets say ER2 09-07,
in the format series choose 4 minutes,
now you go to the chart and open properties.
In the Data Series section type in where it says session begin,
type in 12:02AM
where it says session ends type in 12:00 AM,
Hit Apply , now right click mouse , choose Bar Timer indicator,
hit apply again, and you will see that the Bar timer line on the lower right hand side of the chart says: Bar Timer disabled since current time is out of session time.
thats the problem
I do not want to start my session at 12:00 because the bar close will be 8:32AM when the time comes , I want to print an 8:30 bar close.
Thanks in advance
Carlos
Comment
Latest Posts
Collapse
Topics | Statistics | Last Post | ||
---|---|---|---|---|
Started by philmg, Today, 12:55 PM
|
0 responses
2 views
0 likes
|
Last Post
by philmg
Today, 12:55 PM
|
||
Started by Russ Moreland, Today, 12:54 PM
|
0 responses
2 views
0 likes
|
Last Post Today, 12:54 PM | ||
Started by f.saeidi, Today, 12:14 PM
|
2 responses
5 views
0 likes
|
Last Post
by f.saeidi
Today, 12:47 PM
|
||
Started by TradeForge, 04-19-2024, 02:09 AM
|
2 responses
28 views
0 likes
|
Last Post
by TradeForge
Today, 12:32 PM
|
||
Started by aprilfool, 12-03-2022, 03:01 PM
|
3 responses
327 views
0 likes
|
Last Post Today, 12:31 PM |
Comment