|
|
|||||||
| Charting Support for NinjaTrader Advanced Charting. |
|
|
Thread Tools | Display Modes |
12-13-2008, 08:58 AM
|
#1 |
|
Member
Join Date: Dec 2008
Posts: 35
Thanks: 0
Thanked 0 times in 0 posts
|
OHLC on minute bar - IB vs. esignal
I was comparing data output on a 2 min fdax chart running NT and esignal side by side. Even though IB is a snapshot feed I thought on non-tick chart bars, such as a minute interval chart at least OHLC would be the same. Yet there is a tick or 2 difference on the open or high, low or close. It is not consistent. 1 bar on IB was even 6 ticks "short" (3 full point difference on the close!) compared to esignal. Any idea why that is? Thanks
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Access seconds from minute bar data in OnBarUpdate | shawnj | General Programming | 1 | 12-09-2008 05:07 AM |
| Trade entry based off of High/Low of clicked on 1 minute bar on chart | takacsj | Charting | 1 | 09-19-2008 03:20 AM |
| Alternative to tick based/bar based strategy calculation? (i.e every minute/X ticks) | Elliott Wave | Strategy Development | 9 | 07-11-2008 03:11 AM |
| One Minute Bars / Ten Minutes of Data Per Bar | RJay | Indicator Development | 3 | 06-09-2008 03:27 PM |
| Catch the end of a minute bar on a tick by tick OnBarUpdate event | Fabrice | Automated Trading | 1 | 07-06-2007 06:53 AM |
Threaded Mode