Order modifiacion after execution

[greenr]

Hi i was wondering how you can modify you trade management after trade execution, im sure i can be done because i have seen people do it before

Basically say my ATM is set for

10 contracts

1 stop loss

2 targets

Say i want to split my stop loss into 2 5 lots

and ajust my targets so i can split the targets up

say 1/2 off on 1st target and split the 5 left up for scaling out

How do you do this people...............?

[NinjaTrader_Jason]

Hello greenr,

You can split the stop loss using the Increase and Decrease buttons in the Control Center-->Orders-tab. The stop losses need to be submitted as seperate orders or else it is not possible.

You can split profit targets as follows. Right click in the SuperDOM and select 'Properties'. Set 'Show quick buttons' to True and click OK. The '+ TARGET' button will allow you to split the profit target. More information can be found at the link below.
http://www.ninjatrader.com/support/helpGuides/nt7/adding_and_removing_targets.htm

[greenr]

I know this is the rong section, but this is another issue i want to find out

Is there a way to add a hot key for the charts to show/remove trade executions?

[NinjaTrader_Jason]

Unfortunately such a hot key does not exist.

[greenr]

Originally Posted by NinjaTrader_Jason

Unfortunately such a hot key does not exist.

I think this is a good suggestion then

It is a pain having to go into data series in real time to clear you charts up

Thanks for you help

[NinjaTrader_Jason]

I will forward your suggestion to support such a hot key to development. Thank you for your feedback.

[NinjaTrader_Jason]

The suggestion is assigned to ID# 915.