Vendor Assemblies Loaded...

randyjb · 10-22-2007, 02:41 PM

Is there a way to remove a particular vendor assembly that loads on startup each morning? I get one for NT and also for my KwikPop indicators and those are fine. But I also get one for an indicator set that is no longer supported for NT and I would like to remove all associations of those from my NT setup. It is "vendor assembly "TTWMacci_V1c" loaded. I think it has possibly been creating some errors with my KP indicators, etc. though cannot be sure.

Additionally, someone told me the other day that the ESignal datafeed for NT only is no longer available under the promotional rate. Is that still available, or were they correct?

Best Regards,
randyjb

10-22-2007, 02:41 PM	#1
randyjb Member Join Date: Feb 2007 Location: , , Posts: 68 Thanks: 0 Thanked 0 times in 0 posts	Vendor Assemblies Loaded... Is there a way to remove a particular vendor assembly that loads on startup each morning? I get one for NT and also for my KwikPop indicators and those are fine. But I also get one for an indicator set that is no longer supported for NT and I would like to remove all associations of those from my NT setup. It is "vendor assembly "TTWMacci_V1c" loaded. I think it has possibly been creating some errors with my KP indicators, etc. though cannot be sure. Additionally, someone told me the other day that the ESignal datafeed for NT only is no longer available under the promotional rate. Is that still available, or were they correct? Best Regards, randyjb
	Facebook Twitter YouTube

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Trade through broker and having data feed from data vendor?	gsmaster	Connecting	2	08-29-2007 07:41 AM
Can't find file NinjaTrader.Vendor.cs	scjohn	Indicator Development	8	05-23-2007 06:47 PM