ADD doesnt load in NT7 from IB

[jimbo002]

Hi
Just upgraded to NT7 from NT6.5 and am setting up my charts. I cant get ADD to load. I connect to zenfire 1st then IB second. The TICK loads just fine. ADD loads fine in NT6.5.

I am on a 64bit PC running vista.

Thanks
jimbo

[NinjaTrader_Chip]

Hello jimbo002

Thank you for your post.

Did you use the same connection order in NinjaTrader 6.5?

Have you double-check the symbol mapping in 6.5 for NinjaTrader 7 (for ADD)?

[jimbo002]

Yes, zenfire, then IB.

[NinjaTrader_Chip]

Hello jimbo002

What symbol mapping are you using for ADD in 6.5 & for NinjaTrader 7?

[jimbo002]

Hi
Not sure what you mean. I selected ADD from the Instrument Manager. I went into the Instrument Editor and compared all the parameters. they look identical to the ones in NT6.5.
Not sure what is going on.

[NinjaTrader_Jason]

Hello Jimbo,

What interval does your ADD chart uses in NinjaTrader 7?

Are you able to load ^ADD data if you connect to IB only?

Do you receive real-time data if you select the ^ADD in the Control Center-->Orders-tab?

Try the following. Disconnect from IB and go to Control Center-->Tools-->Options-->Data-tab and click Reset Instruments.

Restart NinjaTrader and check if you can load historical data as per the ^ADD instrument.