signal alert rearming perameters

[ericgood]

i have a strategy programmed that makes an alert when the avg line on the macd crosses below the zero line. Currently the alert happens only once. I need the alert to rearm after the cyan goes back above the zero line again (has a value >0). is there a way to do this within the wizard?

Thanks for your help!

eric

[NinjaTrader_RyanM]

Hello Ericgood,

Alerts can only be rearmed according to the ReArm after seconds property.

What you would probably want to do is set two alerts. One for crossabove and the other for crossbelow. Could then set a short Rearm after seconds value for both.