Set Default in vertical Axis properties

[Jonas]

I like to change the default 'Vertical grid Lines interval (points)' in my charts. When I change it (to 0,001), and click on Set Default, I think that is not saved, since if I open a new chart I must change it again.

[NinjaTrader_Ray]

I like to change the default 'Vertical grid Lines interval (points)' in my charts. When I change it (to 0,001), and click on Set Default, I think that is not saved, since if I open a new chart I must change it again.

I did not think there was a "Set Default" --> Will check into the expected behaviour of this at the panel level.

[Jonas]

OK. For clarification, this is the window

http://www.ninjatrader-support2.com/vb/attachment.php?attachmentid=7506&stc=1&d=1256405813

Thanks